IF YOU REACHED THIS PAGE VIA A SEARCH ENGINE THIS WILL TAKE YOU TO OUR HOME PAGE

This kit contains the 4-40 tap, #43 drill, 2 ea. 4-40 x 1 1/2-inch screws, 6 ea. 4-40 Nylock nuts, 3 ea. 4-40 plain nuts, 3-inches of 5/16-inch square stock drilled at each end and some tie wire. Enough to do two triggers as shown here (and some spare nuts J ). Put a ten dollar bill in a SASE, and mail the whole thing to: Steve Wagner, RD 2 Box 313, Tyrone PA 16686. Of course you can use a check or MO, but I need a SASE. If you want extra NyLock or plain nuts, they are 10 cents each with an order.

You will need:

A propane torch, some silver solder and flux, a drill motor (drill press is better), a tap handle, some cutting oil, file and/or grinding wheel, a hacksaw, a 1/4-inch open end wrench, a center punch and hammer.

THESE ARE NOT IN THE KIT !!!!

Wagner Home Page