This easy to use cutting tool will cut perfect circles, up to 16-inches in diameter (32-inches by special request, E-Mail for price), in any gasket material, cardboard, or plastic. It was designed for cutting head gaskets for Hit 'n Miss and Steam engines, but is perfect for pipe flanges or craft-work as well.

Ý Ý Ý The cutter has an aluminum block, holding a cutter blade, at one end of a steel hairpin.

Ý Ý Ý A needle-point can be slid along the hairpin and "locked" at any point by a wing-nut.

Ý Ý Ý The cutter blade is an easily obtained "break-away" knife blade, enough pre-scored blade material for at least 7 individual cutters is included. One piece of blade is held at the end of the aluminum block by tightening the two 11/32-inch nuts.

Ý Ý Ý The distance from the needle-point to the cutter is set at the radius of the desired circle, the needle point is placed at the center of the intended cut, and the cutter blade (at the end of the aluminum block) is rotated around, and the material is cut !!